how to remove a garbage disposal in a sink

HOW TO REMOVE A GARBAGE DISPOSAL IN A SINK HOW TO
HOW TO REMOVE A GARBAGE DISPOSAL IN A SINK PROFESSIONAL

If the above doesn’t fix your issue then you may need to contact a professional or replace your garbage disposal. If the reset button does not stay retracted, wait 10 minutes and then try again. Press the reset button on the bottom of the disposal. Plug the garbage disposal back into the outlet beneath the sink and turn on the cold water to allow water to flow into the disposal. Use the handle to rotate the grinding plate at the bottom of the disposal until the jam is released. If you don’t have a garbage disposal wrench you can insert the end of a wooden plunger handle into the garbage disposal through the drain opening in the sink. You can also use a ¼-inch hex key and rotate the key back and forth to release the jam. Use a garbage disposal wrench and insert the toll in the center opening in the bottom of an appliance.

Ensure that the garbage disposal is off at both the wall outlet and unplug the garbage disposal from the wall outlet beneath the sink. Garbage Disposal Won’t Reset? Try These 3 Additional Steps The garbage disposal should now work properly. Once the button has been reset, plug it back in and turn the water on cold and switch the garbage disposal to the on position. If the reset button does not stay in after repeated attempts, the grinding plate or wall likely needs to be freed in order to spin freely. It may be helpful to place a mirror under the garbage disposal so you can easily locate the button. This is typically a red button located on the underside of your garbage disposal. Turn off the garbage disposal. Ensure that the garbage disposal is off at both the wall outlet and unplug the garbage disposal from the wall outlet beneath the sink. The strain relief holds all the wires inside the disposal. You may need to use a screwdriver to disconnect the copper ground wire by removing the screw attachment (Image 2). Unscrew each wire nut connector using your hand to disconnect power to the disposal.

HOW TO REMOVE A GARBAGE DISPOSAL IN A SINK HOW TO

How to Reset Your Garbage Disposal in 3 Simple Stepsįollow our simple guide to reset your garbage disposal in three easy steps: Remove the cover plate with a screwdriver, and locate the wire nuts inside (Image 1). Luckily, this is usually a simple fix - here’s what to do.

In any case, when the motor is jammed, it can cause the garbage disposal to overheat and pop the reset button, also known as the overload protector. Many things can cause your garbage disposal to stop running - from turning the appliance on without running water to dropping flat wear down the drain.

How to remove a garbage disposal in a sink